
Notes:

  This application is not complete.

  The level of DXF used is that of AutoSketch II, which is a higher
  level than understood by !Draw.

  DXF only supports filled polygons of 3-4 sides, hence filled areas
  cannot be handled.

  DXF support line widths, but Autosketch II does not recognise them.

  If you wish to see this application completed even with the above
  restrictions, please SHOUT as otherwise development will continue
  on the following basis. I ocassionally use !DXF-CGM and add support
  as required. My diagrams are not noramally that complex so full support
  bar restrictions will take some time.

  Keith Sloan 