
AudioDynamics sampledriver for ProSound 1.03+
=============================================
Version 0.17
 
 Oregan Software Developments


Installation
------------
DON'T INSTALL THIS DRIVER IF YOU DON'T HAVE AN AUDIODYNAMICS CARD INSTALLED
IN YOU COMPUTER. WHEN/IF YOU REMOVE THE AUDIODYNAMICS CARD YOU SHOULD ALSO
REMOVE THIS DRIVER.

Copy the AudioDynam directory to the directory !ProSound.FX.

The driver requires version 5.06 of the DMIControl module to be present in
the RMA. This is checked in the obey-file AudioDynam.!Run. It will attempt
to load the module if it is not already loaded, so it needs to know where
the module is stored.

You should not use any other version of the DMIControl other module than the
version included with this driver. 

Note: RMLoading this version on top of eg. v4.10 or v5.00-5.05 may cause
problems.


In use
------

The sampledriver configuration window is accessed from the Capture submenu
in the Utilities menu, or by clicking the Driver.... button in the Recording
window. It allows you to select the input source as either

        Line            for use with amplifiers, CDs etc.
        Mic             for use with dynamic mics
        Mic (+20dB)     for use with dynamic mics,
                        amplified 20dB before sampling

and to adjust the input gain; this gain is applied in hardware by the
sampler. Of course, you can also adjust the gain in the Record window in
ProSound...

All changes take effect immediately.


Problems
--------

There appears to be a bug in the DMIControl module sometimes causing it to
crash the computer so that a reset is necessary. This happens both with
version 4.10 and with version 5.00-5.06.

You should never have both this driver and any driver for the Concepts Lark
card installed at the same time.
